Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | |||
| electronics-oscillator-in-a-box [2023/03/26 23:29] – renick | electronics-oscillator-in-a-box [2023/03/26 23:30] (current) – renick | ||
|---|---|---|---|
| Line 8: | Line 8: | ||
| - Arrange the components on the circuit board, bending the leads so that the components don't fall out. | - Arrange the components on the circuit board, bending the leads so that the components don't fall out. | ||
| - Cut and place the necessary wires to connect the components; when you cut them, be sure to strip enough at the end so that you can connect them to the leads of your components. | - Cut and place the necessary wires to connect the components; when you cut them, be sure to strip enough at the end so that you can connect them to the leads of your components. | ||
| - | - Prepare the leads for the battery, but do not attach them to the circuit board yet. Prepare the LEDs, but also do not attach them to the circuit board; you should prepare fairly long wires to connect the LEDs to the circuit board. Attach | + | - Prepare the leads for the battery, but do not attach them to the circuit board yet. Prepare the LEDs, but also do not attach them to the circuit board; you should prepare fairly long wires to connect the LEDs to the circuit board. Attach |
| - Also prepare the potentiometer with long leads and prepare to solder them to the circuit board. | - Also prepare the potentiometer with long leads and prepare to solder them to the circuit board. | ||
| - Carefully confirm the layout and all connections on your circuit board. | - Carefully confirm the layout and all connections on your circuit board. | ||